TOS Crapazoid Phaser

Eric Ardros

Sr Member
This is something I've been waiting forever to properly finish up, my B&W crapazoid P2:

l6zd.jpg


For the longest time, all I had done was the P2 body, as shown above. Was having trouble masking off the thumbwheel and painting it without any bleeding underneath the tape (fixed that issue now). The P1 was just done over the weekend, and I gotta say it looks pretty good altogether:

ic05.jpg

mbl0.jpg

afwq.jpg

i6q.JPG


Now I have both of my CaptJTK crapazoid kits built and displayed together in my collection. It's been a good week for me :)
 
Thanks! The other JTK Crapazoid I own was done in the later grey/bronze colour scheme, so now I have one of each version. Pretty kewl :D
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top