1/350 TOS Enterprise clear parts help

vividfury

Active Member
Hi all,

I'm relatively new here and have been inspired by all the fine work to jump back into model making--starting with the 1/350 TOS Enterprise. I want to light the bridge and shuttle bay, but I don't want to buy the Round 2 lighting kit just for the clear parts. Does anyone have parts they aren't using? I'm willing to purchase them, of course.

Thanks!
 
To be honest, the regular parts can be used for lighting FAIRLY easily if you're careful with light-blocking and use the PE. IMO the shuttlebay would be the harder of the two to use but even then, it shouldn't be TOO bad.
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top