Spiffin Alien Xenomorph build

sirspifalot

Active Member
Hello friends. Been lurking quite a bit around here and nothing short of impressive work. Decided it was time to contribute some type of post. So I have "finished" my xeno build. I finished it for a costume party but I wish to do some modifications so I'm gonna call it 95% done. I shall post all of the build photos and such. What I wish to do to this yet is I need to do another pull of of the head and foam fill it. Either partially or all the way because it does not hold its shape the way I want. Also, the tubes on the back are attached via velcro and do not stay on. Industrial strength velcro is a BS term. I'm thinking maybe upgrading to velcro + Neodymium magnets. Any suggestions/ideas for that issue would be great. Enough yapping. PITCHAS!


IMG_1778.JPGIMG_1779.JPGIMG_1780.JPGIMG_1781.JPGIMG_1783.JPGIMG_1786.JPGIMG_1787.JPGIMG_1788.JPGIMG_1789.JPGIMG_1790.JPGIMG_1791.JPGIMG_1794.JPGIMG_1795.JPGIMG_1805.JPG20130813_201050.jpg20130908_131207.jpg20130928_161109.jpg20130829_193852.jpg20131001_074013.jpg20131002_002734.jpg20131006_220151.jpg20131006_220250.jpg
 

Attachments

  • 20131003_003911.jpg
    20131003_003911.jpg
    963.1 KB · Views: 109
  • 20131006_220133.jpg
    20131006_220133.jpg
    916.5 KB · Views: 103
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top