paint wont stick to my FlexFoam X need some input

woodman

Well-Known Member
RPF PREMIUM MEMBER
I've cleaned the surface with 70% alcohol, hot soapy water, naptha and the paint still wont adhere. I've tried Monster Makers latex paints and then I tried some rubber cement paint. Surely I've cleaned the surface well enough to remove the mold release. I'm at a loss.

Woody
 
Woody,
For flexible urethane foam, the right paint is fabric paint...Walmart sells a brand called 'Tulip'
Works really well!
What did you use a s a release when casting your foam?
 
I don't think Tulip will work for my application. I assume you work for Smooth On? The adhesive based flexible paints I'm using should work fine and I've not heard of anyone having the issue of nothing sticking even after several different cleaning solvents have been used. I'm using Ease 2831
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top