slush casting and acrylic resin.

CVWcreations

Active Member
I've not used acrylic resin before, usually stick to polyurethane. Has anybody used acrylic resin, for slush casting or a helmet? If so how did it turn out? Or is it simply just not possible.
 
I've found it to be heavy and not too durable. Probably not strong enough for slush casting without some form of reinforcement.

Polyurethane or fibreglass are far better IMO
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top