Custom Leather/Embossing Stamps

Rotaerc

New Member
Has anyone ever made or had made custom leather stamps? I only found a few sites that had makers stamps at around $200 dollars, and that is way to high. I was thinking I could find a company to CNC mill my stamps, but I don't know where to look. My idea was to use a med-high strength/toughness metal and CNC mill off the negative of the stamped imaged. These could done on plates 1/8-1/4 in total thickness, maybe less and I could mount the plates on handles myself. I just want to find a way to achieve some high detail med-small sized stamps. Any help would be very much appreciated.
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top