1/32 flying sub build

Nice.
I see you opened the cabinet under the bunk.
Did you use the PE set?

I started mine a while back but haven't gotten very far on it after cracking the floor right through one of the light panels while trying to open the hatch.:facepalm
 
Nice.
I see you opened the cabinet under the bunk.
Did you use the PE set?

I started mine a while back but haven't gotten very far on it after cracking the floor right through one of the light panels while trying to open the hatch.:facepalm

Sincere thanks...Yes I scratch Built the details under the bunk. And I did use the PE/Decals from Paragrafx.
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top