My 1st prototype of BTTF Pitbull hoverboard that actually fires

Thread starter jfrancoeur73
Start date Jul 16, 2013

jfrancoeur73

New Member

Jul 16, 2013

Hey guys,
This is a prototype of my 1st attempt at building a BTTF pitbull hoverboard with working engines. The idea is to have a screen accurate board on a display stand with working engines. I am in the early stages of the build, so far I came up with this engine and it actually works. Here are some pics of one engine without paint (I ran out of butane, so its not lit here). Any suggestions or opinions are welcome....Thanks

This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.