Last resort release agent for molds? (ran out of spray)

kwalsh0000

Sr Member
RPF PREMIUM MEMBER
Hey all,

I have my Skyrim helmet in silicone at the moment and I will be doing my plaster mother mold tomorrow and hoping to get a cast out as well (its a one piece silicone glove mold and 2 piece mother mold)

Unfortunately I have just realized that I have no more release agent left (bar vaseline and wax) for doing my casts.

Does anyone have any temp fixes to get me through one cast? I was thinking of using metal powders in the first cast and was thinking that might be enough to help ease the casting out .

Thanks!
 
Oh now thats a good idea! Plus the helmet will smell nice after :) I ended up using some metal powders and it worked a tr
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top