C3PO build

Darthmiller

Well-Known Member
I am really excited to finally start on my C3PO build. The kit is a vac form but I will be adding fiberglass to the entire project

Here we go

image_zps007302eb.jpg
 
I am really excited to finally start on my C3PO build. The kit is a vac form but I will be adding fiberglass to the entire project

Here we go

image_zps007302eb.jpg

Where did you get these parts from?
Did you made them yourself or did you buyed it?
When its buyed, how much you spend on it?

Thats a very awesome projekt, do you plan to chrome it in gold?
I can´t imagine how AWESOME it would look gold chromed!
 
Neato! As long as you were glassing the insides, you could've used a release and just eliminated the styrene altogether, gaining the sharper detail of the inside for your final pieces. Too late now, I guess, unless you used something to dissolve the styrene (which would remove any recasting worries...beyond those generated by whom you got these from to begin with, but that's neither here nor there...)

Looking forward to seeing the plating!
 
Finally some progress! :)
Im waiting since a week.

Most of the people often say they can´t wait to see something finished.
But for me this is a progress, where I really cant waiting to see this thing
finished.

Do you just chrome it gold or do you wheatering it, too?
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top