Dark Knight Manhole Cover 3-D printed

Valor

Sr Member
RPF PREMIUM MEMBER
I wanted to share the first replica I had 3-D printed. A scale replica of the manhole covers used on set in The Dark Knight. I built the design in Adobe Illustrator and brought the .svg file into Tinkercad and had one 3-D printed at Shapeways. I printed it in white and handpainted the iron look. I might make a set of them as coasters!
 

Attachments

  • photo.JPG
    photo.JPG
    577.5 KB · Views: 293
Oh, it's one of my favorite obscure props! I also made a full-size one out of foamboard.
 

Attachments

  • photo (1).JPG
    photo (1).JPG
    816.6 KB · Views: 221
I'm trying to do a run of full-size kits here:


And am selling scale versions of them here:

MOD EDIT: Please do not post Junkyard links, thanks.
 
Last edited by a moderator:
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top