Benf
New Member
Hi guys I'm having some problems with my cameo and although I've read through the threads on here I can't seem to get it sorted so I'm hoping someone will have an idea.
So I got this on Friday and set it all up over the weekend and started cutting my first pieces. Everything was fine I didn't even have to adjust the registration marks the cuts were perfect the only problem is I didn't have the blade deep enough so today I started cutting again now with the blade deeper and all of a sudden it's not cutting accurately. The weird thing is some of the pieces are perfect mainly the ones at the bottom of the page. The weirdest parts though are the biggest part at the top of the photo, if you look at the bottom edge of it it's cut fine for a bit then all of a sudden goes off. The other price that's weird is the piece on the left the tabs side is cut fine but then goes off for the fold lines and the other side. I've attached a photo below if any ones got any ideas that's would be great because this is driving me nuts!!!
Thanks
So I got this on Friday and set it all up over the weekend and started cutting my first pieces. Everything was fine I didn't even have to adjust the registration marks the cuts were perfect the only problem is I didn't have the blade deep enough so today I started cutting again now with the blade deeper and all of a sudden it's not cutting accurately. The weird thing is some of the pieces are perfect mainly the ones at the bottom of the page. The weirdest parts though are the biggest part at the top of the photo, if you look at the bottom edge of it it's cut fine for a bit then all of a sudden goes off. The other price that's weird is the piece on the left the tabs side is cut fine but then goes off for the fold lines and the other side. I've attached a photo below if any ones got any ideas that's would be great because this is driving me nuts!!!
Thanks