outatime26
Active Member
I've just finished my first proper pep file project and it all went quite well.
The sizing is finally right, the first helmet I made was much to big for my small head, so I'm pretty happy with that.
But the horn on the right seems to stick out at a really strange angle. The first one I made didn't stick this far out. But I can't see where I haven't matched it up properly.
I was wondering is it worth taking the horn off, or part of it, and redoing the top portion. Or should I go ahead and stick it with resin then get a heat gun and try and move it into the correct place after?
The sizing is finally right, the first helmet I made was much to big for my small head, so I'm pretty happy with that.
But the horn on the right seems to stick out at a really strange angle. The first one I made didn't stick this far out. But I can't see where I haven't matched it up properly.
I was wondering is it worth taking the horn off, or part of it, and redoing the top portion. Or should I go ahead and stick it with resin then get a heat gun and try and move it into the correct place after?