formula388
Well-Known Member
I have been wanting to build a Pepsi Perfect bottle for a while now. I had an old 3D model drawn but it was not real accurate and I didnt do much with it. After reading up on nitrox's build thread and seeing Gary Weaver II post rubbings and tracings of his screen used bottles, it inspired me to build my own Pepsi Perfect. See original thread and references here.
I started off by using Garys trace and making a 3D model of it. I then exported the file as an STL and sent it to the 3D printer. Using about 9 cubic inches of plastic, with honey comb support in the middle, the model will be done in a few hours. Here are some progress pictures.
This model is without the straw, after seeing how this comes out I will do one with a flip up straw.
Here it is in the printer.
Attached is the 3D drawn model in a perspective view.
I started off by using Garys trace and making a 3D model of it. I then exported the file as an STL and sent it to the 3D printer. Using about 9 cubic inches of plastic, with honey comb support in the middle, the model will be done in a few hours. Here are some progress pictures.
This model is without the straw, after seeing how this comes out I will do one with a flip up straw.
Here it is in the printer.
Attached is the 3D drawn model in a perspective view.