[Noob] Dr. Fate Helmet of Fate Pepakura build

TotallyAquaman

Active Member
I found this wonderful pepakura file for the Helmet of Fate by Dung0Beetle
:)

528088_10200781023032004_1074289052_n.jpg


I'm a completely noob at pepakura and this is my first attempt.

I already have resized, printed and cut the pieces out.
I'm doing just a basic cardboard helmet first to see how I do, i may attempt an EVA foam or a casting later on.
This is all I got done tonight...

421798_10200781004951552_678029579_n.jpg


190340_10200781004911551_365287982_n.jpg


I'll be putting it together tomorrow :)
 
Did you rescale, I printed it a few years ago and the scale was way too small. I was halfway through when I realized, several weeks into the project. I printed it in larger scale and just haven't had the time to start it again. So just be warned you may want to check that first.

Jmax
 
No i didn't.
I knew it wouldn't fit but i really just wanted to practice, however I messed up really badly an the back of it and I haven't touched it since...
I really should though...
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top