Another Batman Utility Belt

alanfan

New Member
Hi,

Just wanted to share my first half-DIY prop - a Batman Begins/TDK/TDKR utility belt (together with some of my other props).

I was lucky enough to get a resin belt in one piece (kbillan sculpt) and all I did was to paint and detail it. The color probably far from screen-accurate but I guess I can live with that for now:

BeltSide.JPG


Beltdone.JPG


centre.JPG


Thanks for watching!
 
damn man that looks really nice. I have one of the cheesy kids costume utility belts that they sell. That setup is pretty damn sweet
 
This is fantastic, I don't suppose you have access to Scan this into an STL file would you? I'd love to set try setting up something similar with a 3D printer.
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top