Silicone mold

BlindSquirrel

BlindSquirrel

Sr Member
I was pouring the second part of a 2-part silicone mold, and I FRAKKING ran out an inch from the top. Can I add new silicone to top it off or do I need to throw it away and re-pour the second half?

I'm using Smooth-on Oomoo-30
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

JV1138
Fine Molds 1:72 Millennium Falcon (Definitive 32" Paintjob)
2
Replies
37
Views
3,441
JV1138
JV1138
JV1138
Fine Molds 1:144 Slave I (Boba and Jango Fett)
Replies
7
Views
1,138
Analyzer
Analyzer
Inlite
Moulding for rotocasting - advice needed
Replies
4
Views
536
JPH
JPH
JV1138
Fine Molds 1:144 Millennium Falcon (32" Paintjob)
2 3 4
Replies
74
Views
8,121
Sym-Cha
Sym-Cha
yaris
Best way to mold this.....????
Replies
13
Views
1,385
edspaged2
E
Back
Top