Question about sealing/painting foam and the primer used

theotherian

New Member
I just picked up some Dupli-color Dark Cherry Metallic and Sunburst Gold for my Iron Man costume.

I plan on using the 1/2 Elmer's Glue, 1/2 Water 5-coat sealing approach, but I'm a little uncertain about primer.

It looks like some people use Dupli-color Primer, and others use Dupli-Color Adhesion Promoter.

Can anyone comment on the differences with these? Should I only be using the promoter if I'm using a Plasti-Dip setup?

Thanks in advance :)
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top