Can I remove top layer of paint without removing paint underneath?

andy19422

Sr Member
I have just aquired this section from the original stargate that was removed so they could take a mould from it to make the new stargates for the TV shows. Before they moulded it they sprayed it with a layer of Red oxide which is peeling in places exposing the original paint. I will be moulding this for my Stargate project so will either have to sand the edges or remove the paint altogether if possible. I would really like to display it with the original paint so doe's anyone know if it's possible to do.
ebay0141.jpg

paint001.jpg
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top