Klingon Baldric

FiremanSpock

New Member
A while back i decided to take a shot at making a replica of Worf's baldric, and after a week assembling each individual link by hand, I think it came out pretty good.
 
Sorry for the delay in responding. This past year life has pretty much kept me extremely busy. I used staples as the rectangular links, using needlenose pliers to bend the prongs into the shape I needed them to be in.
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top