DREDD 2012 - Lawgiver MK2 Aluminium and printed parts

OMG. OMG. I can't wait to see the finished item.

Andyface, can I ask what 3D modelling program you used for this build?

And can anyone tell me if there are other online 3D printing companies around, other than Sh*p*w*ys?

Matthew
 
Thanks Mobius :) Nearing the finish line now, finally received the metal components, these were laser cut from 2mm aluminium. Next step is the clean up, bending, shaping, etc before at long last trying out the prototype assembly. Lots of updates to follow soon...

DB875799-46C5-41F3-814E-952076208C82_zpsgz1ki2vi.jpg
Did you end up finishing the lawgiver?
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top