gorilla glue or titebond + sawdust + fiberglass cloth? / recipes to replace......

treble

New Member
Go-Rilla Ring - by rance @ LumberJocks.com ~ woodworking community

Bending and Laminating

Is it possible to use gorilla glue/titebond, fiberglass cloth, and/or sawdust as an alternative to resin or smooth on plastic? Can it be done with a plaster mold?

Also, this got me thinking. Is there any diy recipes to make alternatives to fiberglass resin/aquaresin or smooth on plastic? All I know is the above stuff and ol' paper mache. I've researched about mixing Durham's rock hard water putty with wood glue and plaster of paris and other stuff but I'm at a loss.
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top