Silhouette Cameo

THE DARK KN1GHT

New Member
Hey guys i have some accuracy problems cutting with my silhouette cameo. if anybody has any ideas on how i can get it to cut using the pepakura viewer for silhouette cameo method
 
Isn't that the newest cutter out? I thought they had written a new pepakura program for that cutter. Have you downloaded the newest version?
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top