Rub N Buff

Darthmagpie

Well-Known Member
I am making a Jango. I had the surface like glass. I Rub N buffed and It looked fantastic. I need to mask for the blue. I let the RNB dry for 2 days but masking tape still pulled of the RNB even though my finger did not. OK, so I used testers gloss coat which I have used before as a final coat, but never tried to mask after, It dulls it a little but I thought it added to the weathering. I tried to mask with tape after 12 hrs and it pulled off.

I hope I can pull it all off, if it still comes off after a few more hours of drying(which I suspect it will), without having to resand.

So, What can I use over the RNB that I can use masking tape on that wont pull off a vertual glass surface?

I have heard of Future floor wax but no nothing about it.

Thanks for the help, Ben
 
I didn't use any coat at all...
Just keep on rubbing with your palm.
The paste will then create a harden surface that don't rubb of.
The tape will probably dull the surface, but don't I think that's a problem, a weathered helmet should't be too shiny in my mind ;)
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top