Pep Y-wing pilot Helmet Build

Blade1286

New Member
Hello RPF!

I'm going to do my best to start and actually finish a Y-wing Pilot's helmet. I have and pep file of it from a few years back. (the file is Dung0Beetle's so all due credit to him.) I've done several papercraft helmets including a snowtrooper, a rebel navy trooper, and an X-wing pilot, but none have been worthy of resin. But enough rambling, on to the reason I'm here. On my past builds scaling has been my biggest problem. If anyone who has a Y-wing helmet could let me know how tall it is (in mm if possible) so i can correctly scale the pep file, it would be greatly appreciated.

Thanks!
-Ethan
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top