My Dark knight suit build (PIC HEAVY)

benable

Active Member
Hey ladies and gents,

Posted this over on the BOTB but thought i'd give everyone here an eyefull.

Hope you enjoy!

This is a project i started last August and have only really jumped onto lately. Most of you will know where the parts came from.

I've been on and off again with this but over the past few days iv'e really tried to devote alot of my time to this.

This is my progress so far.....

This is how i received my parts (borrowed the pic), all latex, untrimmed and not plastidipped. As you can tell i had my work cut out for me lol

2011-08-16_1413101.jpg


The next step i trimmed and assembled the chest the plastidipped. It took agessssssssss lol but only because my scissors were a bit dodgy. One thing to mention though, Plastidip is expensive in Australia!!

2012-04-05164641.jpg


Next step i assemble the Gauntlets and plasti dipped the remaining parts, in total there is around 90 to the entire latex suit


2012-04-05163016.jpg

2012-04-05163005.jpg


Took me about 3 hours to trim properly

2012-04-06124543.jpg


Heres the undersuit before gluing
f5.jpg


The gloves before
2012-04-26170314.jpg


After
2012-06-01224926.jpg


Glued the legs, after a re-glue they looked like this
Finished14.jpg


Finished11.jpg


Glued the stomach, sides and neck
Finished9.jpg

2012-05-31222705.jpg

Finished8.jpg


And here is the suit finished!!!
SL374251.jpg

Finished3.jpg


And me wearing it
SL374254.jpg

SL374264.jpg

SL374262.jpg

SL374268.jpg


Comments and critiques are welcome!

Cheers
Ben
 
Impressive is the least I can say WOW! What or where did you find that under suit? Curious about the cowl? did you make that too??

Simply wow, impressive to say the least.
 
where did you get the parts? could you pm me? im on botb but im not cool enough for their junk yard yet.
 
Used a full body mannequin for the chest but for the legs I filled the legs with paper to fill them out properly.
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top