Galaxyman1701d
Active Member
I am a custom automotive painter/bodyman and have always wanted to build a big enterprise d. After seeing some of the projects on this site I was inspired to start a 1/350 enterprise d. Figured I would start with the nacelles and go from there. Also did a test board to see if I could find a better way to mask the windows, I was very happy with the results. I started out masking the windows, sealer/priming the surface, then built up with three colors for the aztec scheme (the model will have the four colors though), gloss clearcoated with automotive clearcoat, then a sanded down to the tape I layed out for the windows, then I flat clearcoated and pulled the tape. It left a nice clean window edge which I followed with some gloss clear in the window. Any suggestions throughout the build would be appreciated!