I need some serious help(Phoenix area).

Commander Max

Sr Member
For me this is hard to admit.

I need help finishing parts for casting and presentation, I can design and machine the parts. But when it comes to finishing the parts, everything I try doesn't work. I've had people tell me over the phone, I've tried books, websites, vids, advice, etc. I'm at my end.

What I need is someone who can "show" me how to do this. Not tell me but, "show" me in person(no classrooms please), each step of the process. Then take me through it, so I can learn how to do this mysterious art.
I need to learn casting and glassing as well, best to take one thing at a time.
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top