Assassin's Creed Brotherhood doctor's mask

cephalopodprods

New Member
Hi everyone, first post since a long time here, too much projects and comissions for that :p. But here you go, my last prop build: the doctor's mask from Assassin'S Creed Brotherhood. It's also kind of the first step of a bigger project which is the complete costume.

1.jpg

Building up the general shape with foam and foam core on a cheap plaster/cardboard mask from dolorama.

2.jpg

Adding Bondo for carving the shape.

3-1.jpg

Starting the carving / adding more bondo.

4-1.jpg

Final carving and patching.

5.jpg

Texturing done.

6-1.jpg

Adding the details around the eyes, these are pieces of heavy electrical wire insulation glued with epoxy.

7-1.jpg

Little kludged system to hold the wire insulation as the epoxy dries.

8.jpg

Preparing for making the mold,

9-1.jpg

The original sculpt in clay, ready for silicon.

10.jpg

First coat of silicon.

11.jpg

Mold jacket made with plaster, because I didn't have anything fancier.

12.jpg

Inside of the finished mold.

13.jpg

And finally, the first pull, made with smooth cast 30

Tell me what you think about it, I should post the final pictures tomorrow!
 
Not yet, I have the leather for the gloves and the belt but I still need to find the fabric for the main robe...

Otherwise, I took the final pictures of the completed mask! Here they are :

masque1.jpg


masque2.jpg


masque3.jpg
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top