Fringe Observer Tracking Device

renaissance_man

Master Member
RPF PREMIUM MEMBER
I just watched the Fringe episode where you see some more of September's gadgets, I know a few people have made some Fringe props here, so I thought I would post screencaps incase anyone wanted to take a crack at this prop.
Observerdevice.jpg


Juding by the size of the device as held by Peter, and sizing it compared to my Nokia phone I'd estimate it's about 55mm x 120mm and 25mm thick at the top end with the rounded side area and about 20-22mm thick towards the centre.

Good luck to anyone who takes a crack at it, and if you do....post pictures. :)
 
I don't know, it has the look of a dictaphone to me, but I'm really not sure.

It wouldn't be difficult to scratchbuild one from styrene.
 
All the interactive devices used in the program have I pads/Pods as the core device.
The casing are then created and magnetically attached around them.

Season 3 (i think) has a whole segment on the props department. But this prop is talked about in S4, at least on the blu-ray it is.
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top