Latex Mask Help - Any way to stretch them out?

ssdesigner

Sr Member
RPF PREMIUM MEMBER
I got a Michael Meyers "Nightmare" mask today, looks GREAT. Except, when I put it on it fits so tight that it's distorting the look of the mask. Does this latex stretch out a bit over time? Is there a way to heat it up and stretch it out? What do you guys suggest?

Here are my head measurements:




-Ss
 
From my understanding it's only going to shrink a little bit as time goes on. I'm not an EXPERT, but I work with latex quite a bit. You may want to seek an alternative source for a more 'big-head' guy.

-Matt
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top