Terminator bio helmet

What is the name brand of that paint ? WOW I am so in love with this!!!! I want it ( rough cast) from first mold . Please!

Alclad 2 chrome for lexan, the casts i have are from the 2 nd mold the one from the first mold is that one, when i finish the first ill put some on the junkyard
 
Fully finished with lightning, i dont recommend to wear it, but its your choice, due to the alclad chrome, its very sensitive, you can touch it but not too much, so if you want to go to a convention and start taking it off and putting it on to often....you get the point, i left the wire solder exposed without tape or anything so if ya want to modify some electronics it would be easier for you

I think i said everything if you need a pic or some info pm me thanks
0e604191fa56162ba474a036642670af.jpg

8611340c57eea2d7f20aa4e9223aee0b.jpg

f687b176232f1b5490f067f3303881cb.jpg

4ddcf05bb9e5756e121059679849a7ed.jpg

a817270bf23a29debe58a02f0842f9bf.jpg

On my mask
c0df3c06aa90649f110ba37d09d92c5c.jpg


And a video


This one its on the junkyard
 
Last edited:
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top