Liquid Latex Help

U2fan24

Active Member
Hi,
I have a few questions about working with liquid latex.

1. What should I use to mix with it as colouring? (ex tint/paint) Or would it be best to paint after it has dried? I know that you can mix acrylic paints with it, but it will compromise the strength if you use too much. I don't want it stretching out of shape so I will need some advice on this.

2. If I were to pour a mould that's a bit less than 1cm deep, then how long would it take to dry if I filled it all at once? Brushing it on in layers would take forever to achieve the thickness I need.

I would GREATLY appreciate any experienced advice on this.
 
Last edited:
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top