Scratch built Terminator T-800 Endoskeleton

I'd use epoxy putty for the base. You can bake it at a low temperature, smooth it with water and sand it as needed with a wet 320 or 400 grit paper. You should be able to feather it or shape it using water prior to when it cures.
 
Here's a new update, working on the jaw! :p

Doing some buildup with milliput:
318.jpg

319.jpg

320.jpg


Some sanding and priming:
321.jpg

322.jpg

326.jpg


Some more sanding and priming - and further refining the details with milliput:
323.jpg

324.jpg

325.jpg


I'm also doint some work on some smaller parts but I'm focusing on finishing the jaw for now, to be able to mold and cast it asap. :)
 
chanfan said:
Here's a new update, working on the jaw! :p

Doing some buildup with milliput:
http://www.arvidwessman.com/term/318.jpg
http://www.arvidwessman.com/term/319.jpg
http://www.arvidwessman.com/term/320.jpg

Some sanding and priming:
http://www.arvidwessman.com/term/321.jpg
http://www.arvidwessman.com/term/322.jpg
http://www.arvidwessman.com/term/326.jpg

Some more sanding and priming - and further refining the details with milliput:
http://www.arvidwessman.com/term/323.jpg
http://www.arvidwessman.com/term/324.jpg
http://www.arvidwessman.com/term/325.jpg

I'm also doint some work on some smaller parts but I'm focusing on finishing the jaw for now, to be able to mold and cast it asap. :)
Click to expand...

You will sell a ton of them, so you'll get funds to continue on the rest!

It'll be like building a full endo one piece at a time :D I'd subscribe to this.
 
chanfan said:
Eventually I will, yes! :) When I have the entire skull kit finished. It will be a very limited run though!
Click to expand...

Ooooh nice! Though will you be offering full endo casts? (So, do I get in on the skull run, or wait for the full endo... Decisions, decisions! :) )
 
chanfan said:
No I'm not going to offer a complete endoskeleton kit, :p I meant the skull kit, from the neck up - Neck, skull, jaw, eyeballs, and side panels.
When the entire endo i complete, I might eventually offer single parts for sale! :)
Click to expand...

Im in!
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

C
The Terminator (1984) 1:1 Arnold Schwarzenegger Bust With Light Up Eye
Replies
1
Views
2,215
frosty
frosty
RoboForceGo
1:4 T-800 Endoskeleton (1984 ver.) ZBrush WIP
2
Replies
31
Views
7,951
marepa
marepa
Silesky
T-800 face mask
Replies
5
Views
1,188
stussy
stussy
brandonstudio
Terminator 2 Life-sized Bust
Replies
7
Views
1,196
Pumpkinhead
Pumpkinhead
yuumi2891103
Terminator T-800 Face appliance
Replies
6
Views
1,806
yuumi2891103
yuumi2891103
Back
Top