Thomas Bangalter Helmet ( DAFT PUNK )

ArtFunk

Well-Known Member
and finally I started working on the helmet Thomas, I am at the beginning, but should proceed rapidly.

Phase one, MDF structure
 
Last edited:
Re: Thomas Bangalter ( DAFT PUNK )

still a little bit of smoothing, and then a layer of resin over the surface to compact.
 
Re: Thomas Bangalter ( DAFT PUNK )

Meanwhile the putty dried, I devoted myself to experiment on the lathe, which I used for the first time and after 2-3 tests on small pieces of MDF, I decided to try to create the first ear.
I would say that the result is good.
 
Re: Thomas Bangalter ( DAFT PUNK )

Looking good :) cant wait to watch it progress!

Hey, you made it to the rpf too! ( you're stalking me, right? )

Love seeing another thomas build out there, especially following the volpin technique. Looking fantastic so far.
 
Re: Thomas Bangalter ( DAFT PUNK )

Haha totally stalking ;) I actually have no clue how I ended up here, I think it was foam Iron Man suits...

I have a can of expanding foam laying around somewhere, I may have to try this sometime...
 
I made ​​some changes to the cheeks, as seen from the picture comparison, then I added the chin and the frame.
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top