1:1 Star Wars Tauntaun Bust Sculpt

Figuring out where the horns on the top of the head will need to go. These will probably be sculpted seperately and cast in resin then placed on the head sculpt so the fur can be easily sculpted around them without compromising their detail. Don't mind the placment of the ears in these pics as they are just resting on the back board and not positioned correctly.
Tauntaun_08.jpg
 
Last edited:
Woah, great idea! A Full-Size Tauntaun sculpt wasn't something I ever expected to see, but it sounds great. Will be following this with great interest!
 
I used to own an original plaster cast of the Taun Taun sculpt which was used to generate the hair nets for the fur.

If you're interested I'll dig the photos out and post them.

Vince.
 
Here you go, I thought it was an impressive piece and certainly big, the only thing missing were the horns but they weren't required to make the fur.

Taun%20Taun%2002%20W-XL.jpg


Taun%20Taun%2001%20W-XL.jpg


Taun%20Taun%2003%20W-XL.jpg


Hope they help?

Vince.
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top