I forgot to mention before that I am actually constructing two pairs of MAGs. If you look at my photos from the last time I posted, you can see yellow foam. So this second pair is being constructed a little different, but hopefully will go together much easier.
The blue foamies are essentially being skinned with cloth. I'm still undecided what will happen to this pair and they most likely end up stuck on a hover board or similar. I doubt I will be able to make them wearable because there is no lining yet and I really don't know how I will make one at this time.
The yellow set are being constructed differently and has a liner being built as I go. The shoes being made is in pieces by gluing the foam in each part to the cloth, laying that over a second piece, stitching it together and turning it inside out. This is what I was attempting with the canvas, just that the canvas would not stretch enough to get a good finish. If that makes any sense.
Anyhow, this is what the seams look like on this pair.
The part that is glued is actually the liner and the non glued surface (will glue only if required later) pulls tight over the surface.