Hellraiser Puzzle Box

Robiwon

Master Member
Gone but not forgotten.
I used to have a Hellraiser Puzzle Box. I had bought the six brass panels off Ebay. I used a 3 inch cube of walnut as the base hardwood. I sold it about a yaer or so ago. Over the last couple of months I have been trying to find someone who sells just the panles so I can build another. But, no luck of course. Some of the websites that sell boxes either don't offer the panels or are always "out of stock". So here is my question. Is there anyone here that can photoetch a set of brass panles for a puzzle box. There are tons of images, artwork, etc. out there. What would it take to get someone from here to do a set?


http://lh5.ggpht.com/-Hw33x0YzpSM/T...z3OLOOw/s800/Employee%2520Picture%2520001.jpg

http://lh5.ggpht.com/-ILv25xtT5KQ/T...7PlVMv0/s800/Employee%2520Picture%2520002.jpg
 
Hey PBM! Well I looked into having panels etched and for me it was more than I could budget. Earlier this year I picked up a set of Neca panels that I cleaned up. I will be using those on a new box. I'm trying to get a guy at work to get off his duff and cut my block for me. I'll be using a walnut cube again. I love that wood as it is a dense hardwood and keeps sharp edges for a long time.
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top