movie Thor's Mjolnir

BlindSquirrel

Sr Member
I've been building the new hammer on and off between other projects. I've gotten to the point where I was about to complete the head by glueing on the round cap piece and realized I don't have any reference for the proper orientation of the runes. Does anyone have caps or reference for this?

Thanks!
 
Like the build. I am trying my own as well. But am pep'n it. Just about to bondo it all up. Feel free to add more pics, I am love'n this
 
The hammer is a 3/4" MDF hollow box but it still has some decent heft. The runes are all laser cut...the ends were cast in resin from one laser engraved original.
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top