Uruk-Hai Berserker helmet

BlindSquirrel

Sr Member
I made a Pepakura model of this Uruk helmet but finally got around to finishing it.

08.jpg


I used Smooth-On Roto to build up the helmet walls by slush casting on the inside. I then applied Bondo to the outside to smooth out the geometry. Fortunately, I didn't have to sand too much to bring it into spec with Orcish craftsmanship!

13.jpg


I Pepped the back plate but in the end it was just easier to heat form some 1/8" styrene.

16.jpg


The final pics!

30.jpg


31.jpg


32.jpg


35.jpg


Lots more detail and WIP pics on my blog!
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top