My 1:1 Maximillian

They are multiplying......
 

Attachments

  • 13164333_1119668231389330_4083866288130213943_n.jpg
    13164333_1119668231389330_4083866288130213943_n.jpg
    70.7 KB · Views: 171
Finally an arm assembly.

- - - Updated - - -

Claw test
 

Attachments

  • 13507039_10153851800366374_7623999143426746119_n.jpg
    13507039_10153851800366374_7623999143426746119_n.jpg
    47.3 KB · Views: 113
  • 13516207_10153851822016374_4597283243902281151_n.jpg
    13516207_10153851822016374_4597283243902281151_n.jpg
    57.9 KB · Views: 117
  • IMG_2300(1).MOV
    1.5 MB · Views: 99
Wow. Is that arm assembly solid or hollow? It's going to weight quite a bit.

The arms will all be hollow for the electronics. We tested some solid ones for the static arms but they weigh a LOT so all 3 are going to be hollow now. The end tools are solid, and they can be used to crack someone's head in a pinch.
 
Haha, that's starting to look more like Max. I'm just curious, approximately how heavy do you figure it is at this point?
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top