Molding Crow's Nest? (MST3K)

Thread starter MrSinistar
Start date Apr 16, 2011

MrSinistar

Well-Known Member

Apr 16, 2011

Hi guys,

I have a rare Cooper XL7 hockey mask, which is arguably the most important aesthetic part for Crow.

These things are getting rarer and rarer to find and I would like to make a mold from mine and cast some copies. However I have no idea how to do it. I know it's possible as I know a few people in the MST3K community who have done it before but I would like some advice on how to do it properly.

This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.