Another odd super sculpty question.

Wes R

Legendary Member
I was wondering if it was possible to make an RTV mold of super sculpty if it hadn't been cured. I know pouring into an uncured mold made of sculpty doesn't work as it cures partly and fuses to the resin so i didn't want to try and make a mold of the sculpture and have the same thing happen.
I'm sculpting over a mannequin and didn't want to risk using a heat gun to cure it too much and melt the mannequin under it.
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top