My Home Made Saber

Spaceace

Well-Known Member
I wanted a Luke ROTJ saber and thought I would have a go myself, I have never used a Lathe before, my dad has one in his shed so I got some Aluminium bar from work and this is what I ended up with. Everything on the saber I could'nt do on the Lathe I made at work, I have some more accurate measurements now so I might give it another go, anyway some pics...

DSC05670.jpg


DSC05672.jpg


DSC05673.jpg
 
That looks like it is really really well executed. :thumbsup

May I ask, what did you use as a circuit board?

Thanks...the board is .5mm thick aluminium with green vinyl applyed then gold vinyl strips on top. The black switches and red and green lights I cut from acrylic.
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top