TF2 Sniper Rifle - Barrel Help

Jackk

New Member
Hey there everyone. I'm new to the forums and have been looking into getting started with prop making for a while. The first project I wanted to tackle was building the Sniper Rifle from Team Fortress 2.

After measuring out the diameter of the barrel and the bolt, I got some PVC pipe that I'm going to cut, specifically 1-1/4" for the barrel and 3/4" for the bolt. The only trouble I'm running into however is the difference between the outside diameter of the 3/4" pipe and the inside diameter of the 1-1/4" pipe.

My question is, how should I fill the gap? Is there a way I can sleeve the 1-1/4" pipe so the inside diameter is smaller?

Thanks in advance for the help.
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top