Shawshank Redemption - the Rosewood whiskey bottle

ssdesigner

Sr Member
RPF PREMIUM MEMBER
I think that I've found the correct alcohol container finally....just need to secure the label down

shawshank_rosewood_bottle.jpg

To those that have purchased this label, how did you fasten it down? 3M spray mount?
kurtyboy
EmmaInCandyland

-Ss
 
Last edited by a moderator:
I think that I've found the correct alcohol container finally....just need to secure the label down

View attachment 618502

To those that have purchased this label, how did you fasten it down? 3M spray mount?
@kurtyboy
@EmmaInCandyland

-Ss

Milk, you need to use milk ;)

You put milk on a plate, and slightly pass the label on top of it (on the back/white part), so there's enough to stick it onto the bottle, then use a paper towel to press down the label onto the bottle and remove any extra milk left.
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top