Spider-Gwen (Edge of Spider-verse Gwen Stacy)

deleted
 

Attachments

  • ImageUploadedByTapatalk1410588906.312777.jpg
    ImageUploadedByTapatalk1410588906.312777.jpg
    271.6 KB · Views: 301
Last edited:
You'll love that shell! The lens fog up pretty easily so you may want to add some padding to hold the shell out from your face a bit more and some addition holes help. I drilled some in the top of the head and it seemed to do the trick. I also used the same anti-fog wax on the lens that I do on my motorcycle face shield.
Can't wait to see it finished!
 
Slick. Def would add more holes to the shell. Want as much ventilation in there as possible


Sent from my iPhone using Tapatalk
 
No updates yet. I was actually going to reprint it, since the comic is now out and so I know how the side-to-back is truly supposed to look. (Since it was hard to tell from the concept art alone)
Grampsee - I'll definitely add more ventilation, then! :>


Sent from my iPhone using Tapatalk
 
Last edited by a moderator:
No updates yet. I was actually going to reprint it, since the comic is now out and so I know how the side-to-back is truly supposed to look. (Since it was hard to tell from the concept art alone)
@Grampsee - I'll definitely add more ventilation, then! :>

Sent from my iPhone using Tapatalk

The more the merrier
ImageUploadedByTapatalk1411282363.350481.jpg


Sent from my iPhone using Tapatalk
 
Last edited by a moderator:
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top