SWFreak
Sr Member
The barrel is just some PVC pive I had laying around. I sanded and primed it and used silver rub-n-buff for the silver. The barrel runs the whole length of the gun. You can see it creates the sliver "stripe" on the side. If you get this gun and take it apart you'll see what I mean.
The round "dials" at the butt of the gun were covered with 1/8" abs the I cut with a hole saw. These were also sanded, primed and used silver rub-n-buff. The center piece is just lag bolt.
Some parts of the gun I screwed back together, some are glued. Keep in mind this was a rush job that I did in two evenings. I needed to get this done in time for Celebration III.
The round "dials" at the butt of the gun were covered with 1/8" abs the I cut with a hole saw. These were also sanded, primed and used silver rub-n-buff. The center piece is just lag bolt.
Some parts of the gun I screwed back together, some are glued. Keep in mind this was a rush job that I did in two evenings. I needed to get this done in time for Celebration III.