Hi,
This weekend at the local WizardWorld con I picked up a Bladerunner blaster garage kit from Arsenal Models. It's an ok casting that will look nice with some cleanup. But there's some assembly required, and no instructions, so I was wondering if anyone might be able to help.
The triggers and grips look pretty obvious, but where does that rectangular plate go? I did a quick google search for references but didn't see it on any of the angles I found. If you can't tell from the pic, it is very slighly tapered toward one end and slightly convex, with a raised rectangle on one end (which may be a pour spout, IDK) and one small round bump and one small round hole that may represent lights or screws or something.
Also, the left side grip doesn't quite seem to fit right.
This weekend at the local WizardWorld con I picked up a Bladerunner blaster garage kit from Arsenal Models. It's an ok casting that will look nice with some cleanup. But there's some assembly required, and no instructions, so I was wondering if anyone might be able to help.
The triggers and grips look pretty obvious, but where does that rectangular plate go? I did a quick google search for references but didn't see it on any of the angles I found. If you can't tell from the pic, it is very slighly tapered toward one end and slightly convex, with a raised rectangle on one end (which may be a pour spout, IDK) and one small round bump and one small round hole that may represent lights or screws or something.
Also, the left side grip doesn't quite seem to fit right.