Re: Finishing my Prop Projects - ANM2 Part arrival *drool*
Not a bad idea... but cutting a hole into another slave wouldn't look QUITE right... I'll have to think on it.
If I DO use piping, I should be able to take it on and off without doing anything... though a slave would be easier to trash for electronics.
Of course for the price of a slave, I can probably get a beat up replica... IF I was going to bore holes into it.
The tubing does NOT have stamping, btw.
I was just thinking about the + pipe fitting piece. Would it be possible to put a hole in a slave unit for the red button? Then all the slave units would be the same size coming out of the + pipe. Plus you'd have the genuine Graflex top to use elsewhere. Just a thought.
I can't remember, does your bottom tube have stamping? The 5 cell I picked up is blank on the bottom.
Not a bad idea... but cutting a hole into another slave wouldn't look QUITE right... I'll have to think on it.
If I DO use piping, I should be able to take it on and off without doing anything... though a slave would be easier to trash for electronics.
Of course for the price of a slave, I can probably get a beat up replica... IF I was going to bore holes into it.
The tubing does NOT have stamping, btw.